AR-5316E (serv.man4). Service Manual (See also AR-M160 and AR-5316 Service Manuals). - Sharp Copying Equipment Service Manual (repair manual). Page 8

AR-5316E/5320E MAINTENANCE 10-2

*1: Installation of a new toner cartridge allows to display the remaining

quantity.

When a waste toner cartridge is removed from the machine, it must be

put in a polyethylene bag to avoid scattering of toner.

Do not shake or put up the developer cartridge. Otherwise developer

may scatter.

1) When attaching the DV side Mylar, check the position shown in the

figure below and attach it properly. 

2) When attaching the DV side sheet, check the position shown in the

figure below and attach it properly. 
(First of all, attach the DV side Mylar.)

*

Be sure to attach the DV side sheet so that the notch is on the

outside. 

Toner

Life,

16K

Remaining 
quantity 
check *1

a. Press and hold the density adjustment 

LIGHT key for more than 5 sec, and the 
machine will enter the user program 
mode.

b. Press and hold the "%" key for more 

than 5 sec, and the remaining quantity 
will be displayed on the copy quantity 
display in one of the following levels: 
(Remaining quantity display levels: 
100%, 75%, 50%, 25%, 10%, LO)

c. Press the density adjustment LIGHT 

key to cancel.

Remaining 
quantity

NEAR EMPTY
About 10%

EMPTY

LED

ON

Flash

Machine

Operation allowed

Stop

Developer

Life

50K

LED

ON at 50K of the 
developer count

Machine

Selection is available between Not Stop 
and Stop by Service Simulation (SIM 26-
37) Setup.
(If Stop is selected, the LED will flash and 
stop at 50K.)
*

Default: Not Stop

*

Clear: SIM 42-1

Maintenance LED

Selection is available among 50K, 25K, 
10K, 7.5K, 5K, and Not stop with SIM 21-
1.
*

 Default: 50K

*

 Clear: SIM 20-1

Machine

Not stop

[10]MAINTENANCE.fm  2 ページ  ２００６年１２月８日　金曜日　午前１１時１分