Read Sharp AR-507 (serv.man7) User Guide / Operation Manual online
1-6
CHAPTER
1
GETTING STARTED
Power on and off
Auto power shut-off mode
If the auto power shut-off mode is enabled, the copier will
automatically turn off the power once a programmed length of time
has elapsed without any copier operation after the last copy of a run
is made or the power is first turned on. The power switch will
automatically be turned to the “OFF” position.
To turn the power back on, simply turn the power switch to the “ON”
position.
If the auto power shut-off mode is enabled, the copier will
automatically turn off the power once a programmed length of time
has elapsed without any copier operation after the last copy of a run
is made or the power is first turned on. The power switch will
automatically be turned to the “OFF” position.
To turn the power back on, simply turn the power switch to the “ON”
position.
★ KEY OPERATOR See page 8-23 for setting the auto power shut-off
timer. See page 8-29 for enabling or disabling the auto power shut-off
mode.
mode.
Preheat mode
The copier will enter the mode once the set time has elapsed without
any copier operation after the last copy of a run is made or power is
turned on.
When the copier enters the preheat mode, the message “
The copier will enter the mode once the set time has elapsed without
any copier operation after the last copy of a run is made or power is
turned on.
When the copier enters the preheat mode, the message “
PREHEAT
MODE. PLACE ORIGINALS
.” will appear.
In this condition, the fuser in the copier is maintained at a lower heat
level thereby saving power. The preheat level is, however, high
enough to allow the copier to come to a ready condition or begin
copying approximately 60 seconds after any key input is made.
To copy from the preheat mode, make desired copier selections and
level thereby saving power. The preheat level is, however, high
enough to allow the copier to come to a ready condition or begin
copying approximately 60 seconds after any key input is made.
To copy from the preheat mode, make desired copier selections and
press the START (
) key using the normal copying procedure.
★ KEY OPERATOR See page 8-24 for information on setting the preheat
mode.
The
E
NERGY
S
TAR
®
guidelines are
applied to the products only in
Europe, Australia and New Zealand.
The products that meet the
Europe, Australia and New Zealand.
The products that meet the
E
NERGY
S
TAR
®
guidelines carry the logo
shown above. The products without
the logo may not meet the
the logo may not meet the
E
NERGY
S
TAR
®
guidelines.
POWER ON AND OFF
Power save modes
The copier has two power save modes to reduce overall power
consumption and thereby reduce the cost of operation and to conserve
natural resources to help reduce environmental pollution. The two
power save modes are preheat mode and auto power shut-off mode.
consumption and thereby reduce the cost of operation and to conserve
natural resources to help reduce environmental pollution. The two
power save modes are preheat mode and auto power shut-off mode.
★ KEY OPERATOR
The preheat activation time and the auto power shut-off time have been
preset at the factory to 15 min. for preheat mode and 90 min. for auto
power shut-off mode. These times can be changed as described in the key
operator’s guide section. It is suggested that you set appropriate times
according to the actual usage of the copier.
preset at the factory to 15 min. for preheat mode and 90 min. for auto
power shut-off mode. These times can be changed as described in the key
operator’s guide section. It is suggested that you set appropriate times
according to the actual usage of the copier.
Click on the first or last page to see other AR-507 (serv.man7) service manuals if exist.