AR-405 (serv.man30). AR405 Operation Manual-Section 1 - Sharp Copying Equipment User Guide / Operation Manual. Page 16

If this copier has been programmed in the auditing mode, it will not
function until an assigned 5-digit account number has been entered.

★ KEY OPERATOR

Auditing accounts

The initial status of the message display will be:

ENTER YOUR ACCOUNT NUMBER. –––––

●

Enter your account number using the 10-key pad.

●

As each digit is entered, the dashes in the display will change to
asterisks.

The following message will appear after the number is entered.

ACCOUNT STATUS: COPIES MADE 000,000

           COPIES REMAINING 000,000

“COPIES REMAINING” will appear only if account limit has been
set using a key operator program.

★

★

★

★

★ KEY OPERATOR

●

The message will be displayed for several seconds, then change
to the following message.

READY TO COPY.

●

When a copy run is performed, the following message will
appear.

READY TO COPY.

PRESS [AUDIT CLEAR] WHEN FINISHED.

(In some regions, [ACC.#-C] is displayed in place of [AUDIT
CLEAR].)

●

In the interrupt copy mode (see page 2-20), the following
message will appear instead of the message above.

READY TO COPY. WHEN COPYING IS

FINISHED, PRESS [INTERRUPT].

NOTE:
If an unassigned number is entered, the message display will show
“

ENTER YOUR ACCOUNT NUMBER.-----

”, indicating that the

number was not accepted.

When the key operator program of account number security has
been set:
If an unassigned number is entered three successive times, the
copier will not accept another number for one minute, and the
following message will appear.

PLEASE SEE YOUR KEY OPERATOR FOR

ASSISTANCE.

★

★

★

★

★ KEY OPERATOR

1

2

3

4

5

6

7

8

9

0

C

P

CLEAR

PROGRAM

AUDIT CLEAR

INTERRUPT