Read Sharp AR-285 (serv.man36) User Guide / Operation Manual online
8-4
CHAPTER
8
KEY OPERATOR PROGRAMS
A complete list of all key operator programs is provided below. These programs can
only be accessed by first entering the key operator code number.
The key operator programs are grouped into four categories: account control, other
function settings, timer settings, and enable/disable settings.
only be accessed by first entering the key operator code number.
The key operator programs are grouped into four categories: account control, other
function settings, timer settings, and enable/disable settings.
Category
Program Name
Function
Page No.
Account Control
Auditing Mode
Enables or disables the basic auditing mode, which
8-9
controls access to copier.
Number of Copies
Displays the total number of copies made against
8-9
per Account
account numbers.
Resetting Account
Resets all audit accounts or selectively resets
8-10
individual accounts.
Account Number
Registers accounts, deletes accounts, changes an
8-10
Control
account number, or prints all registered account
numbers.
numbers.
Account Limit
Sets the maximum number of copies which can be
8-12
Setting
made against a registered account number.
Account Number
Guards against trial and error entering of audit
8-13
Security
account numbers.
Other Function
Key Operator Code
Changes the key operator code number.
8-14
Settings
Number Change
Exposure
Lightens or darkens copies in the automatic
8-14
Adjustment
exposure mode.
Toner Save Mode
Reduces toner consumption.
8-14
Add or Change
Adds or changes reduction and enlargement preset
8-15
Extra Preset Ratios
copy ratios.
Setting a Maximum
Sets the maximum number of copies that can be
8-15
Number of Copies
selected.
Initial Margin Shift
Sets the initial margin shift values.
8-16
Setting
Erase Width
Sets the initial amount of the erase area.
8-16
Adjustment
Initial Status
Sets the copier’s initial settings in the ready
8-17
Setting
condition.
Stream Feeding
Enables the stream feeding mode for copying
8-17
Mode
from the document feeder.
Staple Position
Sets the initial stapling position setting for an optional
8-18
Setting
finisher (AR-FN1).
KEY OPERATOR’S GUIDE
Key operator programs
Click on the first or last page to see other AR-285 (serv.man36) service manuals if exist.