AR-285 (serv.man159). Parts Guide Correction - Corrona Wire. (WHITE) - Sharp Copying Equipment Technical Bulletin (repair manual). Page 2

Read Sharp AR-285 (serv.man159) Technical Bulletin online

(4) Wire cutters should always be used when cutting the excess length.
The remaining length of extra wire should be within 1 mm. The wire cutting operation
should be carried out so that there is no stress placed on the wrapped portion of the
wire. (Please refer to the figure shown below.)
(5) The charger wire should be stretched so that the length of the tension spring
is approximately 10±0.5 mm. (Please refer to the figure shown below.)
(6) The charger wire should lie in the V groove of the TC case.
Sharp Electronics (UK)Ltd., Technical Services Group
Approximately 60°
Within 1 mm
Scribe line
Tension spring
Charger wire
The length of the tension
spring (10
±
0.5 mm) should
be measured from the scribe line
wire of the TC case, and should
be less than 1 mm.
Page of 2
Display

Download Sharp AR-285 (serv.man159) Technical Bulletin