Read Sharp AR-250 (serv.man9) User Guide / Operation Manual online
3-7
CHAPTER
3
4
Select the desired erase mode.
●
Select “EDGE ERASE”, “CENTRE ERASE” or “EDGE+CENTRE
ERASE” on the touch panel. The selected erase mode will be
highlighted.
ERASE” on the touch panel. The selected erase mode will be
highlighted.
5
Adjust the amount of edge erase and/or centre erase if
needed.
needed.
●
The amount can be adjusted between 0 mm and 20 mm in 1 mm
increments (0" and 1" in 1/8" increments).
increments (0" and 1" in 1/8" increments).
6
Press the upper “OK” key on the touch panel.
7
Make all other desired copier selections and press the
START (
START (
) key.
●
If the optional document feeder is used, scanning of originals and
copying will start.
copying will start.
●
If the document glass is used in the SORT mode, proceed to the
next step.
next step.
8
Replace the finished original with the next original after
the START (
the START (
) key indicator lights up, and then press
the START (
) key. Repeat this step until all originals
have been scanned. Then, press the “READ-END” key
on the touch panel.
on the touch panel.
●
Copying will start at this time.
●
To cancel the ERASE function, select the ERASE function again
and press the “CANCEL” key.
and press the “CANCEL” key.
SPECIAL FUNCTIONS
Erase
READY TO COPY.
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
CANCEL
1
OK
OK
(0~1)
inch
ERASE
EDGE ERASE
CENTRE ERASE
EDGE+CENTRE
ERASE
CANCEL
10
OK
OK
(0~20)
mm
mm
CANCEL
1
OK
OK
(0~1)
inch
C
CLEAR
INTERRUPT
CA
CLEAR ALL
START
ERASE
READ-END
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
WHEN FINISHED, PRESS [READ-END].
AUTO
EXPOSURE
PAPER SELECT
100%
COPY RATIO
AUTO A4
Click on the first or last page to see other AR-250 (serv.man9) service manuals if exist.