AR-250 (serv.man8). AR250 Operation Manual-Section 1 - Sharp Copying Equipment User Guide / Operation Manual. Page 34

●

When the optional document feeder is being used, the copier will
stop after completing the copying of the originals which have
been fed into the document feeder. The INTERRUPT indicator
will blink until the copier becomes ready for interrupt copying.
Then the INTERRUPT indicator will light up.
The copier will return to the initial setting.

●

If the copier has been programmed in the auditing mode, the
account number entry message will appear. Enter your account
number using the 10-key pad. The number of copies of the
interrupt copying will be accumulated against this account
number.

●

The copier will reset itself to the functions which were in use

before the INTERRUPT (

) key was first pressed.

●

If scanning of originals has been already complete, the original
need not be replaced.

 Interrupting a copy run

INTERRUPT can be used to temporarily stop a long copy run so that
another job can be run.

●

INTERRUPT will not function during duplex copying (when an
optional duplex module (AR-DU1) is installed).

●

Duplex copying cannot be selected during interrupt copying even if
an optional duplex module (AR-DU1) is installed.

●

When the optional dual tray output unit (AR-TR1) is installed,
interrupt copies are output to the second tray of the unit.

★

★

★

★

★ KEY OPERATOR

3

6

INTERRUPT

CA

CLE

C

CLEAR

INTERRUPT

CA

CLEAR ALL

START

3

6

INTERRUPT

CA

CLE