Read Sharp AR-205 (serv.man8) Service Manual online
[5] UNPACKING AND
INSTALLATION
1. Installing conditions
1) Copier installation
Do not install your copier in areas that are:
•
damp, humid, or very dusty
•
exposed to direct sunlight
•
poorly ventilated
•
subject to extreme temperature or humidity changes, e.g., near an
air conditioner or heater.
air conditioner or heater.
•
Be sure to allow the required space around the machine for servic-
ing and proper ventilation.
ing and proper ventilation.
2) Power source
•
Use an exclusive-use power outlet. If the power plug of this
machine is inserted into a power outlet commonly used with other
illumination units, flickers of the lamp may be result. Use a power
outlet which is not used commonly with any illumination units.
machine is inserted into a power outlet commonly used with other
illumination units, flickers of the lamp may be result. Use a power
outlet which is not used commonly with any illumination units.
•
Avoid complex wiring.
3) Grounding wire connection.
•
To avoid danger, be sure to connect a grounding wire. If no
grounding wire is connected and a leakage occurs, a fire or an
electric shock may be result.
grounding wire is connected and a leakage occurs, a fire or an
electric shock may be result.
2. Removal of protective material and
fixing screw
1) Remove all tapes and protective material.
•
Remove all tapes, then open the document cover and remove
the protective material of sheet shape
the protective material of sheet shape
2) Remove the fixing screw.
•
Use a coin to remove the fixing screw.
•
The fixing screw is required when transporting the machine.
Keep it in the tray. (Refer to the later description.)
Keep it in the tray. (Refer to the later description.)
3. Installation of developing cartridge
1) Open the manual paper feed tray.
2) Lift the knob and slide the side cover gently.
3) Open the front cover.
•
Hold the both edge gently and open the front cover.
4) Remove the screw from the upper section of the insertion port of
the developer cartridge.
5) Shake a new developer cartridge a few times as shown.
•
Shake it horizontally as shown with the arrow.
4" (10 cm)
AR-205
AR-205 [5] UNPACKING AND INSTALLATION 05/24/1999
5 – 1
Click on the first or last page to see other AR-205 (serv.man8) service manuals if exist.