Read Sharp AR-161 (serv.man9) Service Manual online
6) Put No. 2/3 mirror base unit on the positioning plate again, push
the projections on the front frame side and the rear frame side of
the copy lamp unit to the corner frame, and tighten the wire fixing
screw.
the copy lamp unit to the corner frame, and tighten the wire fixing
screw.
(3) Main scanning direction (FR direction) distortion
adjustment
This adjustment must be performed in the following cases:
•
When the mirror base drive wire is replaced.
•
When the lamp unit, or No. 2/3 mirror holder is replaced.
•
When a copy as shown is made.
1) Set A3 (11" x 17") white paper on the original table as shown
below.
2) Open the original cover and make a normal (100%) copy.
3) Measure the width of the black background at the lead edge and
at the rear edge.
If the width (La) of the black background at the lead edge is equal
that (Lb) at the rear edge, there is no need to execute the follow-
ing procedures of 4) ~ 7).
that (Lb) at the rear edge, there is no need to execute the follow-
ing procedures of 4) ~ 7).
4) Loosen the mirror base drive pulley fixing screw on the front frame
side or on the rear frame side.
•
When La < Lb
Turn the mirror base drive pulley on the rear frame side in the
arrow direction B. (Do not move the mirror base drive pulley
shaft.)
Turn the mirror base drive pulley on the rear frame side in the
arrow direction B. (Do not move the mirror base drive pulley
shaft.)
•
When La > Lb
Turn the mirror base drive pulley on the front frame side in the
arrow direction A. (Do not move the mirror base drive pulley
shaft.)
Turn the mirror base drive pulley on the front frame side in the
arrow direction A. (Do not move the mirror base drive pulley
shaft.)
5) Tighten the mirror base drive pulley fixing screw.
<Adjustment specification>
La = Lb
(4) Sub scanning direction (scanning direction)
distortion adjustment
When there is no skew copy in the mirror base scanning direction and
there is no horizontal error (right angle to the scanning direction), the
adjustment can be made by adjusting the No. 2/3 mirror base unit rail
height.
there is no horizontal error (right angle to the scanning direction), the
adjustment can be made by adjusting the No. 2/3 mirror base unit rail
height.
Before performing this adjustment, be sure to perform the horizontal
image distortion adjustment in the laser scanner section.
image distortion adjustment in the laser scanner section.
This adjustment must be performed in the following cases:
•
When the mirror base wire is replaced.
•
When the copy lamp unit or No. 2/3 mirror unit is replaced.
•
When the mirror unit rail is replaced or moved.
•
When a following copy is made.
Lb
La
A
B
AR-161
AR-160/161 FM/E [7] ADJUSTMENT 11/27/1998
7 – 5
Click on the first or last page to see other AR-161 (serv.man9) service manuals if exist.