Read Sharp AR-155 (serv.man7) Service Manual online
3. CHECKING PACKED COMPONENTS AND
ACCESSORIES
Open the carton and check if the following components and ac-
cessories are included.
cessories are included.
4. UNPACKING
Be sure to hold the handles on both sides of the copier to un-
pack the copier and carry it to the installation location.
pack the copier and carry it to the installation location.
5. REMOVING PROTECTIVE PACKING
MATERIALS
1) Remove pieces of tape and protective cover. Then open the
original cover and remove protective materials (a) and (b).
2) Use a coin (or suitable object) to remove the screw.
Store the screw in the paper tray because it will be used if
the copier has to be moved.
the copier has to be moved.
6. INSTALLING THE TD CARTRIDGE
The TD cartridge replacement required ( ) indicator will light
up when toner is needed. If copying is continued while the
indicator is lit, copies will gradually become lighter until the
copier stops and the indicator begins blinking. Replace the old
TD cartridge by following the procedure given below.
up when toner is needed. If copying is continued while the
indicator is lit, copies will gradually become lighter until the
copier stops and the indicator begins blinking. Replace the old
TD cartridge by following the procedure given below.
Note:
● After the copier stops, it may be possible to make a few
more copies by taking the TD cartridge out of the copier,
shaking it horizontally, then reinstalling it. If copying is
not possible after this operation, replace the TD
cartridge.
shaking it horizontally, then reinstalling it. If copying is
not possible after this operation, replace the TD
cartridge.
● During long copy run of a dark original, the ready ( )
indicator may blink, the indicator light up, and the
copier stop, even though toner is left. The copier will feed
toner up to 2 minutes and then the ready ( ) indicator
will light up. Press the print ( ) key to restart copying.
copier stop, even though toner is left. The copier will feed
toner up to 2 minutes and then the ready ( ) indicator
will light up. Press the print ( ) key to restart copying.
1) Ensure that the bypass tray is open and then open the side
cover while pressing the side cover open button.
2) Remove the CAUTION tape from the front cover and
remove the two protective pins from the fusing unit by pull-
ing the strings upward one at a time.
ing the strings upward one at a time.
3) Push gently on both sides of the front cover to open the
cover.
4) Remove the TD cartridge from the bag. Remove the protec-
tive paper. Hold the cartridge on both sides and shake it
horizontally four or five times.
horizontally four or five times.
Copier
Power cord
Line cord
FAX model
only
FAX model
only
TD cartridge
Drum cartridge
(installed in copier)
4 or 5 times
AR-F151
5 – 2
Click on the first or last page to see other AR-155 (serv.man7) service manuals if exist.