AR-122E (serv.man13). Sect 6. Copy Process - Sharp Copying Equipment Service Manual (repair manual). Page 3

Read Sharp AR-122E (serv.man13) Service Manual online

AR-122E/152E/153E/157E  COPY PROCESS  6 - 3
Step-3: Developing (DC bias)
A bias potential is applied to the MG roller in the two component
magnetic brush developing method, and the toner is charged negative
through friction with the carrier.
Non-image area of the drum surface charged with negative potential
repel the toner, whereas the laser exposed portions where no negative
charges exist, attract the toner. As a result, a visible image appears on
the drum surface.
Toner is attracted over the shadowed area because of the developing
bias.
Step-4: Transfer
The visible image on the drum surface is transferred onto the print
paper by applying a positive charge from the transfer corona to the
backside of the print paper.
Step-5: Separation
Since the print paper is charged positively by the transfer corona, it is
discharged by the separation corona. The separation corona is
connected to ground.
Step-6: Cleaning
Toner remaining on the drum is removed and collected by the cleaning
blade. It is transported to the waste toner collecting section in the
cleaning unit by the waste toner transport roller.
S
N
N
:Carrier (Magnetized particle)
:Toner (Charge negative by friction)
(N) (S) Permanent magnet
(provided in three locations)
MG roller
 
DC
400V   8V
About DC 5.2kV
Page of 4
Display

Click on the first or last page to see other AR-122E (serv.man13) service manuals if exist.