AM-400 (serv.man9). Chapter 1 (General Description). - Sharp Copying Equipment Service Manual (repair manual). Page 6

AM-400DE

1 – 6

Take the following points into consideration when selecting a site for
this model.

ENVIRONMENT

• The machine must be installed on a level surface.

• Keep the machine away from air conditioners, heaters, direct sun-

light, and dust.

• Provide easy access to the front, back, and sides of the machine.

In particular, keep the area in front of the machine clear, or the orig-
inal document may jam as it comes out after scanning.

• The temperature should be between 10 - 30

°C.

• The humidity should be between 20% and 85% (without conden-

sation).

ELECTRICITY: AC 220 - 230 V, 50 Hz, earthed AC outlet (U.K.,
Eire:230 V, 50 Hz, earthed (3-prong) outlet).

Caution!

• Connection to a power source other than that specified will cause

damage to the equipment and is not covered under the warranty.

• If your area experiences a high incidence of lightning or power

surges, we recommend that you install a surge protector for the
power and telephone lines. Surge protectors can be purchased at
most telephone specialty stores.

If the machine is moved from a cold to a warm place...

Condensation may form on the reading glass if machine is moved from
a cold to a warm place, this will prevent proper scanning of documents
for transmission. Turn on the power and wait approximately 2 hours
before using machine.

TELEPHONE JACK

A standard telephone jack must be located near the machine. This is
the telephone jack commonly used in most homes and offices.

• Plugging the fax machine into a jack which is not jack may result in

damage to the machine or your telephone system. If you do not
know what kind of jack you have, or need to have one installed,
contact the telephone company.

1) Attach the document feeder tray.

Slide the output tray into the machine as shown. When it stops, lift
the end slightly and push in so that the tray locks in place.

Important: The output tray must be attached correctly or the
machine will not operate.

2) Releasing the scanner.

Before plugging in the power cord, pull the scanner release toward
you to release the scanner lock.
• Caution: Plugging in the power cord without releasing the scan-
ner lock may damage the machine.

If you need to move the machine:
• In the event that you need to move the machine to a new location,
disconnect the telephone line cord before unplugging the power
cord. After you have unplugged the power cord, push the scanner
release back in to lock the scanner.
• After moving, release the scanner lock first and then plug in the
power cord. Connect the telephone line last.

3) Connecting the power cord.

Plug the power cord into a 220 - 230 V, 50 Hz, earthed AC outlet
(U.K., Eire:230 V, 50 Hz, earthed (3-prong) outlet).
• Caution: Make sure the scanner has been released as explained
on the previous page before plugging in the power cord.
• The power outlet must be installed near the equipment and must
be easily accessible.

Note: The shape of the power plug varies by country.

• The machine does not have a power on/off switch. The power is
turned on and off by simply plugging in or unplugging the power
cord.
• Whenever you unplug the power cord, wait at least 5 seconds
before plugging it back in.
• If you area experiences a high incidence of lightning or power
surges, it is recommended that you install surge protectors for the
power and telephone lines. Surge protectors can be purchased
from your dealer or at most telephone specialty stores.

POWER

CORD