AL-800 (serv.man7). AL800 840 Service Manual-Simulation codes - Sharp Copying Equipment Service Manual (repair manual). Page 17

Operation/
Procedure

1) The currently set code of the scanner (writing) motor OFF timing after completion of printing is displayed.

2) To change the set content, enter the code of your desired setting and press the start button.

Setting code

Scanner (writing) motor OFF timing

0

 

0  sec

1

30 sec

2

60 sec

3

90 sec

Note

30 - 1

Purpose

Operation test/check

Function
(Purpose)

Used to check the operation of the sensors and detectors in the paper feed section, the paper transport section,
and the paper exit section and their control circuit.

Section

Item

Operation

Operation/
Procedure

The paper detectors operations can be checked with lighting of the lamps on the operation panel.

Detector name

Monitor lamp

Paper empty detector

PE SENSOR

Developer cartridge replacement lamp

Paper entry detector

PIN SENSOR

Paper jam lamp

Paper exit detector

POUT

Photoconductor cartridge replacement lamp

Paper size (width) detector

PAPER SIZE SW

Zoom lamp

Note

43 - 1

Purpose

Setting

Function
(Purpose)

Used to set the fusing temperature.

Section

Fixing (Fusing)

Item

Operation

Operation/
Procedure

1) The currently set code of the fusing temperature (normal state) is displayed.

2) To change to the standard set temperature, press the code corresponding to the standard set temperature and

press the start button.

Be sure to set to "0" (160°C). 
If set to other than "1," a trouble may occur.

Set code

Fusing temperature (°C)

0

160

1

150

2

155

3

165

4

170

5

175

Note

Be sure to set to the specified value (default).

43 - 4

Purpose

Setting

Function
(Purpose)

Used to set the fusing temperature after 20th sheet in the multi print mode.

Section

Fixing (Fusing)

Item

Operation

8 – 17