Read Sharp AL-1644 (serv.man14) Service Manual online
AL-1633/1644 UNPACKING AND INSTALLATION 5-2
B. Installing the TD cartridge
1) Push gentry on both ends of the front cover and open it.
2) Remove the new TD cartridge from the bag. Hold the cartridge on
both sides and shake it horizontally four or five times.
3) Remove the protective cover from the TD cartridge by unlatching
three cover hooks from the holes on the cartridge and then pulling
the cover in the direction indicated by the arrow in the illustration.
the cover in the direction indicated by the arrow in the illustration.
4) Insert the TD cartridge along the guides until it locks in place while
pushing the lock release lever.
If there is any dirt or dust on the TD cartridge, remove it before
installing the cartridge.
5) Close the front cover.
The TD cartridge replacement required indicator will go out.
Note:
•Even after a new TD cartridge is installed, the TD cartridge replacement
•Even after a new TD cartridge is installed, the TD cartridge replacement
required indicator may still light up, indicating that copying cannot be
resumed (toner is not fed sufficiently). In this case, open and close the
front cover. The machine will feed toner again for about two minutes and
front cover. The machine will feed toner again for about two minutes and
then copying can be resumed.
•Before closing the front cover, make sure that the TD cartridge is
correctly installed.
•When closing the front cover, gently hold both ends.
4 or 5 times
[05]UNPACKING.fm 2 ページ ２００３年１１月２８日 金曜日 午前９時１６分
Click on the first or last page to see other AL-1644 (serv.man14) service manuals if exist.