AL-1530 (serv.man5). AL1530 Service Manual - Sharp Copying Equipment Service Manual (repair manual). Page 8

3) Store the pressure plate lock (removed in step 2)) together with

the screw (removed during unpacking) in the front of the paper
tray in the locations shown. Secure the lock in the position by
rotating in the direction of the arrow.

4) Adjust the paper guides on the paper tray to the copy paper width

and length. Squeeze the lever of paper guide A and slide the
guide to match with the width of the paper.
Move paper guide B to the appropriate slot as marked on the tray.

5) Fan the copy paper and insert it into the tray. Make sure the

edges go under the corner hooks.

Note: Do not load paper above the maximum height line (    ). Ex-

ceeding the line will cause a paper misfeed.

6) Gently push the paper tray back into the copier.

Note: After loading copy paper, to cancel the blinking "P" without res-

tarting copying, press the clear ( > ) key. The "P" in the display
will go out and the ready (    ) indicator will light up.

This copier has two document input stations - a single pass feeder
(SPF) for automatic document feeding and an original table for manual
handling of documents. The SPF is designed to hold up to 30 originals
measuring from A5 to B4 and weighing from 52 to 90g/m

2

.

1) Ensure that paper of the desired size is set in the paper tray.When

copying onto paper larger than A4 size, pull the paper output tray
extension out.

2) Turn the power switch on.

Pressure plate lock

Screw

A

B

AL-1530

4  –  3