AL-1456 (serv.man6). Unpacking and installation - Sharp Copying Equipment Service Manual (repair manual). Page 8

AL-1555 UNPACKING AND INSTALLATION 5 - 8

4. When the "Select Program Folder" window appears, click the

"Next" button.

The setup program will start to copy the files.

If the dialog box asking "If you have TIFF files saved using
Photo-Shop or Imaging for Windows you should hit Skip"
appears. Answer the question to continue the Sharpdesk instal-
lation.

5. Click the "Finish" button when the message to inform you of the

completion of the installation appears.

9) Click the "Close" button when the message to inform you of the

completion of the installation appears.

• After the installation, a message to restart your computer may be

displayed. In this case, click the "Yes" button to restart your com-
puter.

10) Connect the parallel interface cable.

You have completed the installation of all the software.

• For parallel interface connection ensure that your computer and

MFP are turned off before connecting the cable (see page 5-8).

This unit includes both USB and parallel interface connectors.
Interface cables for connecting the unit to your computer are not
included with this unit.

Caution:

• If you intend to use the unit as a scanner, it must be connected to

your computer with a USB interface cable. The scanner function can-
not be used if the unit is connected with a parallel cable.

• USB is available with a PC/AT compatible computer that was origi-

nally equipped with USB and had Windows 98, Windows Me, Win-
dows 2000 Professional, Windows XP Professional or Windows XP
Home Edition preinstalled.

• Do not connect the interface cable before installing the MFP driver.

The interface cable should be connected during installa-tion of the
MFP driver.

1) Obtain a shielded USB interface cable.

2) Insert the cable into the USB interface connector located on the

rear of the unit.

3) Insert the other end of the cable into the interface connector of your

computer, or the USB hub connected to your computer.

1) Obtain an IEEE1284 shielded parallel interface cable.

2) Ensure that your computer and unit are turned off.

3) Insert the cable into the parallel interface connector located on the

rear of the unit, and fasten with clasps.

4) Insert the other end of the cable into the interface connector of your

computer.

This printer uses a bi-directional parallel interface. Use the supplied
interface cable.

36-pin ACON RBE42-36K1153 female connector or equivalent con-
nector

Shielded type bi-directional parallel interface For best results, use a
printer interface cable which is IEEE1284 compliant.

The pin numbers and signal names are listed in the following table.

Pin No.

Signal name

Pin No.

Signal name

1

STB

19

GND (STB RET)

2

DATA1

20

GND (DATA1 RET)

3

DATA2

21

GND (DATA2 RET)

4

DATA3

22

GND (DATA3 RET)

5

DATA4

23

GND (DATA4 RET)

6

DATA5

24

GND (DATA5 RET)

7

DATA6

25

GND (DATA6 RET)

8

DATA7

26

GND (DATA7 RET)

9

DATA8

27

GND (DATA8 RET)

10

ACKNLG

28

GND 
(ACKNLG RET)

11

BUSY

29

GND (BUSY RET)

12

PE (Paper End)

30

GND (PE RET)

13

SLTC

31

INPRM

14

AUTO LF

32

FAULT

15

(NC)

33

(NC)

16

GND (0 V)

34

(NC)

17

FG

35

+5 V

18

+5 V

36

SLTC IN

1

18

36

19