AL-1456 (serv.man6). Unpacking and installation - Sharp Copying Equipment Service Manual (repair manual). Page 3

AL-1555 UNPACKING AND INSTALLATION 5 - 3

5) Hold the tab of the protective cover and pull the tab to remove the

cover.

6) Gently insert the TD cartridge until it locks in place.

7) Close the front cover and then the side cover by pressing the

round projections near the side cover open button. The 

 indica-

tor will go out and the ready ( 

 ) indicator will light up.

Note: When closing the covers, be sure to close the front cover

securely and then close the side cover. If the covers are closed

in the wrong order, the covers may be damaged.

Note: This copier is equipped with two paper trays. Load copy paper

into the two paper trays.

1) Raise the handle of the paper tray and pull the paper tray out until

it stops.

2) Remove the pressure plate lock. Rotate the pressure plate lock in

the direction of the arrow to remove it while pressing down the
pressure plate of the paper tray.

3) Store the pressure plate lock that was removed in step 2 and the

screw that was removed when unpacking the machine in the front
of the paper tray. To store the pressure plate lock, rotate the lock
to fix it on the relevant location.

4) Adjust the paper guides on the paper tray to the copy paper width

and length.
Squeeze the lever of paper guide (A) and slide the guide to match
with the width of the paper.
Move paper guide (B) to the appropriate slot as marked on the
tray.

5) Fan the copy paper and insert it into the tray. Make sure the edges

go under the corner hooks.

Note: Do not load paper above the maximum height line (

).

Exceeding the line will cause a paper misfeed.

6) Gently push the paper tray back into the copier.

Note: After loading copy paper, to cancel the blinking "H" without

restarting copying, press the clear (

) key. The "P" in the

display will go out and the ready (

) indicator will light up.

1) Ensure that the power switch of the copier is in the OFF position.

Insert the attached power cord into the power cord socket at the
rear of the copier.

2) Plug the other end of the power cord into the nearest outlet.

The supplied CD-ROM includes software for this unit.

Permits you to operate scanning function of this unit with TWAIN-com-
pliant and WIA-compliant application.

Enables you to use the printer function of this unit with your computer.

The print state and information on current printing are displayed on the
status monitor window. 

An integrated software environment that makes it easy to manage doc-
ument and image files and launch applications.

Button Manager enabling the SCANNER key located on the unit.

Paper 
guide  (B)

Paper 
guide  (A)