Read Sharp AL-1456 (serv.man5) Service Manual online
1,000 copier more are made, the indicator starts blinking and
machine will hard-stop (after current job) until a new cartridge is
installed. End life of photoreceptor cartridge displays 3-digits x 2-
line (total 6-digits) by pressing CLEAR key for five seconds in user
DEVELOPER CARTRIDGE REPLACEMENT indicator lights up to
warn the user. If the Toner Developer Cartridge is not replaced in
that time, the Ready Lamp changes to blinking and then start to
supply the toner after around 10 copies. (Cartridge replacement
lamp continues to light.) If toner density is not back to specific level
after two minutes, the READY indicator goes out and Toner Devel-
oper indicator starts blinking, and the copier stops.
Use to sequentially select the exposure modes: AUTO, MANUAL or
PHOTO. Selected mode is shown by a lit indicator.
Use to adjust the MANUAL or PHOTO exposure level.
Selected exposure level is shown by a lit indicator.
Use to start and terminate user program setting.
Use to sequentially select preset reduction/enlargement copy ratios.
Selected copy ratio is shown by a lit indicator.
Displays the specified copy quantity, zoom copy ratio, user program
code, and error code.
400% in 1% increments.
closed or the power turned off and on).
unit is in the auto power shut-off mode.
been installed using the installer. To scan using this method, you
must first complete the settings in Button Manager in your com-
puter. For more information on Button Manager, see the online
manual or the help file for Button Manager.
the scan job will be stored and scanning will begin when the print
job is completed.
being performed. (On line)
Windows OS you are using)