AL-1456 (serv.man29). Sect. 3 Loading Paper - Sharp Copying Equipment User Guide / Operation Manual. Page 4

Read Sharp AL-1456 (serv.man29) User Guide / Operation Manual online

17
3
BYPASS FEED (including special paper)
The multi-bypass tray (AL-1555) or the single bypass (AL-1045/AL-1255/AL-1456) can be used 
to feed standard paper, transparency film, labels, envelopes, and other special purpose paper. 
Paper measuring from A6 to A4 and in the weight range of 52 to 128g/m
2
 can be used in this 
tray. (For paper weighing from 104  to 128g/m
2
, A4 is the maximum size.)
The multi-bypass tray (AL-1555)
1
Open the multi-bypass tray and extend the tray.
2
Set the paper guides to the paper width. Insert the paper (print 
face down) all the way into the multi-bypass tray.
3
Press the tray select (
) key to select the multi-bypass tray.
The multi-bypass tray (AL-1555) can hold maximum of 50 sheets of 
paper. (Capacity will vary depending on the type of paper loaded.) The 
single bypass (AL-1045/AL-1255/AL-1456) can hold one sheet of paper.
The original image must be smaller than the paper or media for 
copying. If the original image is bigger than the paper or media, this 
may cause smudges on the edges of the copies.
To close the multi-
bypass tray, perform 
step 1 and then step 2 in 
the illustration and push 
the round projections at 
the right of the tray until 
they click.
Paper must be fed narrow side into the feed slot.
Transparency film, labels, and other special purpose papers must 
be fed individually.
When copying onto transparency film, remove each copy promptly. Do not let 
copies stack up. When loading an envelope, make sure that it is straight and flat.
Print face
Page of 5
Display

Click on the first or last page to see other AL-1456 (serv.man29) service manuals if exist.