Read Sharp AL-1217D (serv.man8) User Guide / Operation Manual online
17
3
BYPASS FEED (including special paper)
The multi-bypass tray (AL-1457D, AL-1555) or the single bypass (AL-1217D) can be used to
feed standard paper, transparency film, labels, envelopes, and other special purpose paper.
Paper measuring from A6 to A4 and in the weight range of 52
feed standard paper, transparency film, labels, envelopes, and other special purpose paper.
Paper measuring from A6 to A4 and in the weight range of 52
g/m
2
to 128
g/m
2
can be used
in this tray. (For paper weighing from 104
g/m
2
to 128
g/m
2
, A4 is the maximum size.)
The multi-bypass tray (AL-1457D, AL-1555)
1
Open the multi-bypass tray and extend the tray.
2
Set the paper guides to the paper width. Insert the paper (print
face down) all the way into the multi-bypass tray.
face down) all the way into the multi-bypass tray.
3
Press the tray select (
) key to select the multi-bypass tray.
•
The multi-bypass tray (AL-1457D, AL-1555) can hold maximum of 50
sheets of paper. (Capacity will vary depending on the type of paper
loaded.) The single bypass (AL-1217D) can hold one sheet of paper.
•
The original image must be smaller than the paper or media for
copying. If the original image is bigger than the paper or media, this
may cause smudges on the edges of the copies.
To close the multi-
bypass tray, perform
step 1 and then step
2 in the illustration
and push the round
projections at the
right of the tray until
they click.
•
Paper must be fed narrow side into the feed slot.
•
Special papers such as transparency film ,labels and envelopes
must be fed one sheet at a time through the multi-bypass tray.
•
When copying onto transparency film, remove each copy
promptly. Do not let copies stack up.
Print face
Click on the first or last page to see other AL-1217D (serv.man8) service manuals if exist.