AL-1045 (serv.man28). Sect. 5 Making Copies - Sharp Copying Equipment User Guide / Operation Manual. Page 5

Read Sharp AL-1045 (serv.man28) User Guide / Operation Manual online

50
Automatic exposure adjustment
The automatic exposure level can be adjusted to suit your copying needs. This level is
set for copying from the original table and copying from the SPF/RSPF respectively.
1
When adjusting the automatic exposure level for copying from 
the SPF/RSPF, place an original in the original feeder tray and 
make sure that the SPF/RSPF (
) indicator lights up. When 
adjusting the level for copying from the original table, make 
sure that no original is left in the original feeder tray.
2
Press the exposure mode selector key to 
select the photo (
) mode.
3
Press and hold down the exposure mode 
selector key for approximately 5 seconds. 
The photo (
) indicator will go out and 
the AUTO indicator will begin to blink. One 
or two exposure indicators corresponding 
to the automatic exposure level which has 
been selected will light up.
4
Press the light (
) or dark (
) key to 
lighten or darken the automatic exposure 
level as desired. If exposure level 2 is 
selected, the two left-handmost indicators 
for that level will light up simultaneously. 
Also, if level 4 is selected, the two right-
handmost indicators for that level will 
light up simultaneously.
5
Press the exposure selector key. The AUTO indicator will stop 
blinking and light up steadily.
This automatic exposure level will remain in effect until you change it 
again by this procedure.
Page of 6
Display

Click on the first or last page to see other AL-1045 (serv.man28) service manuals if exist.