Read Sharp AL-1045 (serv.man28) User Guide / Operation Manual online
to scan an original once only and make up to 99 copies. This feature allows for
improved workflow, reduced operating noise from the copier and reduced wear and
tear on the scanning mechanism. This feature provides for a higher reliability.
bypass tray (p.17), and check the paper size (p.14).
If paper is not loaded, see page 15. If you are using the single bypass, check
the paper size and then proceed to the next step without loading paper.
If you are using the original table, see "Using the original table" (p.47).
If you are using the SPF/RSPF, see "Using the SPF/RSPF" (p.48).
When copying onto A4 paper or a large size, pull out the paper output tray
If you wish to copy using the initial settings (p.13), proceed to the next step.
To set the number of copies, see page 49.
To adjust the resolution and contrast settings, see page 49.
To enlarge or reduce the copy, see page 51.
To print on both sides of the paper, see page 52.
To change the tray used, see page 53.
Do not press the start ( ) key. Insert a
sheet of paper into the single bypass.
using the single bypass.
print data in the unit's memory is printed (interrupt copying). When this is done, the
print data remaining in the computer is not sent to the unit. When the copy job ends,
press the clear (
remaining print data will be sent to the unit and printing will resume. Interrupt copying
is not possible during a print job using the single bypass.
the original scale and the centering (
tray is in progress. This will cause a misfeed.
begin when the copy job is completed.
copies. Also image loss 4.5 mm in total can occur along the other
edges of the copies. It can be 6 mm (max.) at the trailing edge of the
second copy of two-sided copying.
crumpled original, press down the original cover lightly. If the original
cover is not securely closed, the copies may be striped or blurred.
allow copying of a large original (AL-1045)
weighting from 52 to 90 g/m
original feeder tray.
SPF/RSPF. If the stream feeding mode has been enabled using user program No.4,
the SPF/RSPF (
originals placed in the original feeder tray will be fed and copied automatically. If the
stream feeding mode has been disabled, the start (
SPF/RSPF. The default setting of the stream feeding mode is "ON". See "USER
any staples or paper clips from them.
sure to flatten them. If not, original misfeeds may result.
SPF/RSPF is not properly closed.
recommended that such originals be copied from the original table.
the SPF/RSPF, but should be placed directly on the original table.
the copies. Also image loss (max. 4.5 mm in total) can occur along the
other edges of the copies. It can be 6 mm (max.) at the trailing edge of
the second copy of two-sided copying.
Ensure that no indicator is lit among the original to copy indicators.
mode. To adjust the copy density manually or to copy photographs, the exposure
level can be adjusted in five steps manually.
select the manual (
2 is selected, the two left-handmost
indicators for that level will light up
simultaneously. Also, if level 4 is selected,
the two right-handmost indicators for that
level will light up simultaneously.