PN-ZB01 (serv.man2) - Sharp Monitor Service Manual (repair manual). Page 4

iii

 

The PWB’ s of this model employs lead-free solder. The “LF” marks indicated on the PWB’s and the Service Manual mean 
“Lead-Free” solder. Thealphabet following the LF mark shows the kind of lead-free solder. 

If the soldering iron tip is discolored black during soldering work, cleanand file the tip with steel wool or a fine filer. 

If different-kind solder remains on the soldering iron tip, it is melted together with lead-free solder. To avoid this, clean the soldering iron 
tip after com-pletion of soldering work. 

Since lead-free solder includes a greater quantity of tin, the iron tip may corrode easily. Turn ON/OFF the soldering iron power frequently.  

Since the melting point of lead-free solder is about 220˚C, which is about 40˚C higher than that of conventional lead solder, and its 
soldering capacityis inferior to conventional one, it is apt to keep the soldering iron in contact with the PWB for longer time. This may 
cause land separation or mayexceed the heat-resistive temperature of components. Use enough care to separate the soldering iron 
from the PWB when completion of soldering isconfirmed. 

Since the melting point of lead-free solder thread is about 40˚C higher than that of conventional lead solder thread, the use of the 
exclusive-use solder-ing iron is recommendable. 

When repairing a lead-free solder PWB, use lead-free solder thread. Never use conventional lead solder thread, which may cause a 
breakdown or anaccident. 

Since the operation is failed if there is a monitor of the same IP address setting in the connected network environment, 
perform the LAN connectionsetting and then connect to the network. 

This monitor can remember e-mail addresses and other data.Before transferring or disposing of this monitor, initialize all settings by 
executing ALL RESET1. Excuting ALL RESET2 will not reset e-mail addresses and similar data.

The battery supplied with this product contains traces of Lead.
For EU:

For Switzerland:

The used battery is to be returned to the selling point.

For other non-EU countries:

Please contact your local authority for correct method of disposal of the used battery

.

“BATTERY DISPOSAL”

U.S.A.ANDCANADAONLY

The crossed-out wheeled bin implies that used batteries should not be put to the general householdwaste!  
There is a separate collection system for used batteries, to allow proper treatment and recycling in accordance with 
legislation. Please contact your local authority for details on the collection and recycling schemes.

THIS PRODUCT CONTAINS A LITHIUM PRIMARY (MANGANESS DIOXIDE) MEMORY BACK-UP BATTERY THAT MUST BE 
DISPOSED OF PROPERLY. PLEASE CONTACT YOUR LOCAL SHARP DEALER OR AUTHORIZED SERVICE REPRESENTATIVE 
FOR ASSISTANCE IN DISPOSING OF THIS BATTERY.

Bi-Sn-Ag

b

p

Solder composition

Solder composition code

a

Sn-Ag-Cu
Sn-Ag-Bi
Sn-Ag-Bi-Cu

z

Sn-Zn-Bi

i

Sn-In-Ag-Bi

n

Sn-Cu-Ni

s

Sn-Ag-Sb
Bi-Sn-Ag-P

Lead-Free

Solder composition 
code (Refer to the 
table at the right.)

a

5mm

“CAUTION”

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.  
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS