PN-Y555 (serv.man4) - Sharp Monitor User Guide / Operation Manual. Page 8

8

E

•  This product is for use indoors.
•  A mounting bracket compliant with VESA specifications is

required.

•  Since the monitor is heavy, consult your dealer before

installing, removing or moving the monitor.

•  Mounting the monitor on the wall requires special expertise

and the work must be performed by an authorized SHARP
dealer. You should never attempt to perform any of this
work yourself. Our company will bear no responsibility
for accidents or injuries caused by improper mounting or
mishandling.

•  Use the monitor with the surface perpendicular to a level

surface. If necessary, the monitor may be tilted up to 20
degrees upward or downward.

•  This monitor should be used at an ambient temperature

between 32°F (0°C) and 104°F (40°C).

 Provide enough space around the monitor to prevent heat

from accumulating inside.

Unit: inch [mm]

7-7/8 [200]

2

[50]

2

[50]

2 [50]

2

[50]

2 [50]

Unit: inch [mm]

5/16 [7]

5/16 [7]

7-7/8 [200]

2

[50]

Power LED

•  If it is difficult to provide sufficient space for any reason

such as the installation of the monitor inside a housing, or
if the ambient temperature may be outside of the range
of 32°F (0°C) to 104°F (40°C), install a fan or take other
measures to keep the ambient temperature within the
required range.

•  Do not block any ventilation openings. If the temperature

inside the monitor rises, this could lead to a malfunction.

•  Do not place the monitor on a device which generates heat.

•  Adhere to the following when installing the monitor in its

portrait orientation. Failing to adhere to the following may
cause malfunctions.
- Install the monitor such that the power LED is located on

the bottom side.

- Set the THERMAL SENSOR SETTING on the SETUP

menu to PORTRAIT. (See page 27.)

•  Use the supplied vertical sticker when you install the

monitor in portrait orientation.

Vertical sticker 

(Operation panel)

Vertical sticker 

(Logo)

Do not remove the factory-affixed sticker but affix the
sticker over it. Be careful not to cover the remote control
sensor or buttons.