Read Sharp PN-V601 (serv.man2) Handy Guide online
CONFIDENTIAL
CONFIDENTIAL
Multi Display Setup Manual <Rev1.0 > September.30, 2010
2
Display surface
Perspective drawing of the rear
side view
Grip Points
The display surface is made of glass. Please use rear handgrip or handle by the edge of the display while
installing and moving. It is possible to cause damage and malfunction of display.
Please don’t apply physical pressure to the bezel such as bending or pulling on the bezel.
Please don’t apply physical pressure to the bezel such as bending or pulling on the bezel.
Precautions
of installation and handling (1)
Prior to installing the PN‐V601, please refer to following items carefully in order to use PN‐V601 for long term reliable service.
Please use rear handgrip or handle by the edge of the display in
installing and moving. Please don’t handle any other part of the
display. The PN‐V601 is high – density product so that please pay attention not
to let the edge of PV‐V601 support the entire weight
load. Please take extra caution to make sure that weight load each display is supported only by the mounting system and not a
neighboring display when building a multi‐screen wall.
Method of interim storage of the display after taking it out from the box
‐
Interim storage using the temporary stand is recommended.
‐
When you must keep the LCD surface side down without temporary stand, please prepare a protection board
larger than the display, and put a protecting sheet like blanket on it, and confirm enough there are neither debris nor a projection
within the range where the LCD surface side comes in contact directly. Please execute the work
only after the greatest care is taken so that the LCD surface should not hit the edge of the protection board underneath.
Protection board larger
than PN‐V601
than PN‐V601
protecting sheet
like blanket
PN‐V601
‐
Do not set the PN‐V601 on a protection
board smaller than itself to avoid the
contact with corner of the board.
‐
Use a protecting sheet like blanket
‐
Do not apply force from
the above.
Please set the PN‐V601 in the center
of the protection board/protecting sheet
and be careful to avoid the contact
with corners of the board.
Precautions for Installation and moving
Click on the first or last page to see other PN-V601 (serv.man2) service manuals if exist.