PN-R903 (serv.man7) - Sharp Monitor User Guide / Operation Manual. Page 7

7

E

•  This product is for use indoors.
•  A mounting bracket is required. 
•  Since the monitor is heavy, consult your dealer before 

installing, removing or moving the monitor.

•  Mounting the monitor on the wall requires special expertise 

and the work must be performed by an authorized SHARP 
dealer. You should never attempt to perform any of this 
work yourself. Our company will bear no responsibility 
for accidents or injuries caused by improper mounting or 
mishandling.

•  Use the monitor with the surface perpendicular to a level 

surface. If necessary, the monitor may be tilted up to 20 
degrees upward or downward. 

•  This monitor should be used at an ambient temperature 

between 32°F (0°C) and 104°F (40°C). Provide 
enough space around the monitor to prevent heat from 
accumulating inside.

7-7/8 [20]

Unit: inch [cm]

2 [5]

2

[5]

2

[5]

Unit: inch [cm]

2 [5]

7-7/8 [20]

2

[5]

2

[5]

2 [5]

2 [5]

•  If it is difficult to provide sufficient space for any reason 

such as the installation of the monitor inside a housing, or 
if the ambient temperature may be outside of the range 
of 32°F (0°C) to 104°F (40°C), install a fan or take other 
measures to keep the ambient temperature within the 
required range.

•  Temperature condition may change when using the monitor 

together with the optional equipments recommended by 
SHARP. In such cases, please check the temperature 
condition specified by the optional equipments.

•  Do not block any ventilation openings. If the temperature 

inside the monitor rises, this could lead to a malfunction.

•  Do not place the monitor on a device which generates heat.

•  Adhere to the following when installing the monitor in its 

portrait orientation. Failing to adhere to the following may 
cause malfunctions. 
-  Install the monitor such that the power LED is located on 

the bottom side.

- Set the MONITOR on the MONITOR menu to PORTRAIT.

(See page 26.)

•  Use the supplied vertical sticker when you install the 

monitor in portrait orientation.

Logo

Operation panel

Do not remove the factory-affixed sticker but affix the 
sticker over it. Be careful not to cover the remote control 
sensor or buttons.

•  This monitor is fixed to the temporary stand used in the 

package for transportation when shipped from the factory. 
Please note that this stand is for temporary use only until 
the monitor is properly mounted.