PN-R903 (serv.man5) - Sharp Monitor Service Manual (repair manual). Page 3

PN-R903/R703/R603　OUTLINE OF THE PRODUCT

 1 – 2

*

1

D-Sub input terminal only

*

2

Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such
cases, please check the temperature condition specified by the optional equipments.

3

When AUTO INPUT CHANGE is set to OFF.

*

*

4

When “STANDBY MODE” is set to “STANDARD”. When “STANDBY MODE” is set to “LOW POWER”: 0.5W

■　PN-R903

■　PN-R603

■　PN-R703

*

Note that the values shown are approximate values.

When mounting the monitor, be sure to use a wall-mount bracket.
SHARP recommends using M6 screws and tighten the screws.
Note that screw hole depth of the monitor is 3/8 inch (10 mm). Loose mounting may cause the product to fall, resulting inserious personal injuries as
well as damage to the product. The screw and hole should come together with over 5/16 inch(8 mm) length of thread. Use a bracket which has 
been approved for UL1678 standard, and which can endure at least 4 times or more the weight of the monitor.
Don’t use the impact driver.

36-1/16 [916]

62-1/8 [1578]

1-9/16
[39.4]

7

/16

[1

1.2]

7

-7

/8

 [200]

7-7/8
[200]

7-7/8
[200]

Unit: inch [mm]

VESA holes *

Opening width(60-11/16 [1541])

Opening height (34-1/2 [

8

77

])

3-15/16

[100]

3-15/16

[100]