PN-R603 (serv.man7) - Sharp Monitor User Guide / Operation Manual. Page 26

26

E

n

MONITOR
Select the installation direction of the monitor.

LANDSCAPE ............Landscape orientation

PORTRAIT ...............Portrait orientation
OSD H-POSITION
Adjusts the horizontal display position of menu screen.
OSD V-POSITION
Adjusts the vertical display position of menu screen.
OPERATION MODE
MODE1 ......OFF IF NO OPERATION is set to ON, and STANDBY MODE is set to LOW POWER.  

(These settings can not be changed.)

MODE2 ......Will perform standard operation. OFF IF NO OPERATION is set to OFF, and STANDBY MODE is set to 

STANDARD. These settings can be changed.

STANDBY MODE
When STANDARD is selected, startup time from standby mode is reduced. Note, however that, more power will be consumed 

in standby mode.

When LOW POWER is selected, current consumption is reduced while the monitor is in standby mode. Note, however, that the 

startup time from standby mode becomes longer. 

If set to LOW POWER, certain RS-232C commands cannot be used in standby mode, and control via LAN will be disabled.
OFF IF NO OPERATION
Determines whether or not to set the monitor to go into standby mode when there is no operation from the remote control unit, 

RS-232C commands, or LAN for over 4 hours.
POWER ON DELAY
If SET is set to ON, you can delay the screen display after the monitor is turned on. When ON is selected, set the delay time 

with INTERVAL (interval can be set up to 60 seconds in units of 1 second). 

When this function is activated, the power LED flashes (at approx. 1 second interval) in orange. 
SELF ADJUST
On a D-SUB[RGB]/DVI-I (analog) screen, specify whether to perform screen adjustment automatically or not. 

When ON is selected, the screen is automatically adjusted when its resolution is 800 x 600 or higher and the timing of input 

signals changes. “ADJUSTING” appears on the screen during the adjustment. 

If SELF ADJUST is set to ON, set the time it takes to start the SELF ADJUST function in START TIMING.

For images with black edges, etc., depending on the signal, adjustment may not be possible. In this case select OFF. (Perform 

manual adjustment of the screen.)