PN-K321 (serv.man5). Setup Manual - Sharp Monitor User Guide / Operation Manual. Page 7

Read Sharp PN-K321 (serv.man5) User Guide / Operation Manual online

ENGLISH
5
E
Installing the stand (supplied)
Caution
•  Disconnect all cables from the monitor.
•  Firmly tighten the installation screws (supplied) with the hex 
wrench (supplied).
•  Ensure that you have sufficient space to work.
n
Attaching the stand
Remove all packaging materials before starting work.
To prevent the table (etc.) from being damaged by the stand 
pedestal, spread a thick, soft cloth (blanket, etc.) and work on 
the cloth.
1.  Insert the stand strut into the packaging material (upper 
left) as shown.
Front
Packing material 
(upper left)
2.  While supporting the stand pedestal with your hand, 
fasten to the stand strut with the supplied countersunk 
screws (M4 x 6 without washers) (x5).
Use the supplied hex wrench.
Countersunk screw 
(M4 x 6 without washers)
Insert by hooking the tab
Pedestal
*  A bag containing the screws 
(supplied) and hex wrench 
(supplied) is attached to 
the round hole in the stand 
pedestal.
3.  Spread a thick, soft cloth (blanket, etc.) that will prevent 
damage to the LCD panel on a stable flat surface where 
the entire monitor can be placed, and place the monitor 
with the LCD panel face down on the cloth.
4.  Place the stand on the monitor.
Hook the tab on the stand under the mounting plate (pre-
installed on monitor).
Tab
5.  Fasten the stand to the monitor with the supplied 
screws (M4 x 10 with washers) (x4).
Use the supplied hex wrench.
• Landscape
Screw 
(M4 x 10 with washers)
• Portrait
Operation buttons
Screw 
(M4 x 10 with washers)
Front
Fixing pin
2
1
*  If the monitor will be used in the portrait orientation, pull out 
the fixing pin (1), and insert it into the hole (2) as shown 
above.
*  To remove the stand, place the monitor and stand as 
shown above and remove the screws.
Caution
•  Adhere to the following when installing the monitor in its 
portrait orientation. Failing to adhere to the following may 
cause malfunctions.
  -  Install the monitor such that the operation buttons are 
located on the top side.
  -  Set the MONITOR on the MONITOR menu to PORTRAIT. 
(See OPERATION MANUAL.)
Page of 44
Display

Click on the first or last page to see other PN-K321 (serv.man5) service manuals if exist.