Read Sharp PN-E802 Handy Guide online
Preparation for despatch
After the unit has been tested and confirmed as working, you need to load the model specific
application – Service Tool
If you are unfamiliar with the application or have not yet installed the program, please refer to the
operation manual provided with the “Service Tool” application.
Only if you have replaced the I/F PWB or the EEPROM, you will need to re-write ALL data (O).
After the unit has been tested and confirmed as working, you need to load the model specific
application – Service Tool
If you are unfamiliar with the application or have not yet installed the program, please refer to the
operation manual provided with the “Service Tool” application.
Only if you have replaced the I/F PWB or the EEPROM, you will need to re-write ALL data (O).
Write the “Firmware” to the display
Run – Main Firmware
Run – Main Firmware
If the unit has an OPTION BOARD fitted, write the “PN-ZBxx Firmware”
Run – PN-ZBxx Firmware
Run – PN-ZBxx Firmware
For PN-L units, write the “Touch Panel Firmware” to the display
Run – TouchPanel FIrmware
Run – TouchPanel FIrmware
Reset the unit
Check the service manual and perform a factory reset
Check the service manual and perform a factory reset
Write the “Usage Time” of the display
Run – Usage Time
Run – Usage Time
For PN-V units, reset the “Bright Reset” settings on the unit
Run – Panel Data Reset
Run – Panel Data Reset
If required, write the “White balance” settings for the display (O)
Run – White Balance
Run – White Balance
For PN-L units If required, write the “Gamma” settings for the display (O)
Run – Gamma
Run – Gamma
If required, write the “Serial Number” of the display (O)
Run – Serial Number
Run – Serial Number
If required, write the “Monitor Temperature” of the display (O)
Run – Temp Watch
Run – Temp Watch
If required perform “Flicker Adjustment” (O)
Run – Flicker Adjustment
Run – Flicker Adjustment
Display