PN-E421 (serv.man5) - Sharp Monitor User Guide / Operation Manual. Page 36

36

E

36

You can configure settings related to SNMP.

SNMP SETTING
Set whether to enable or disable SNMP.
VERSION
Set the version of the SNMP to be supported.
COMMUNITY NAME 1 to 3
Set the name of the community required for the access.
USER 1 to 3
Set the user name, password, authentication method and 

other options required for access.
TRAP SETTING
Set whether to enable or disable the trap function.

When this function is enabled, a trap will be sent when the 

monitor is turned on.
TRAP WHEN AUTHENTICATION FAILS
Set whether the trap function sends a notification when 

authentication fails.
TRAP ADDRESS & PORT NO.
Set the destination address and port number of the 

notification sent by the trap function.

Caution

•  After you set SNMP, click [Switch the main power of 

monitor off and on now.] or turn off the monitor and then 

turn it on again with the main power switch. When the 

monitor restarts, wait about 30 seconds and then start the 

next operation.

TIPS

•  Depending on the SNMP settings, a short delay may occur 

before the SNMP is usable. (About 2 minutes)

•  Up to 16 alphanumeric letters and symbols can be used for 

the community name, user name and password.

You can display a specific URL in the URL INFORMATION 

field on the INFORMATION screen when an error occurs in 

the monitor. (See page 32.)

URL INFORMATION
Enter the URL to display on the INFORMATION screen when 

an error occurs on the monitor.

Up to 64 alphanumeric characters or symbols can be used.
CONDITION
Specify the condition to display the URL.
CONFIRMATION
The home page of the specified URL is displayed.

You can check whether the URL you entered is correct.

TIPS

•  It is also possible to specify the message text, such as the 

name of a contact or a telephone number, to be displayed 

instead of the linked URL.