PN-E421 (serv.man5) - Sharp Monitor User Guide / Operation Manual. Page 11

E

11

n

TREBLE
Adjusts the volume of treble-level sound.
BASS
Adjusts the volume of bass-level sound.
BALANCE
Adjusts the balance of the audio sound between right and left.
RESET
Resets the values of the AUDIO menu items to the factory preset values.
Select “ON” and then press  .

n

OSD H-POSITION
Adjusts the horizontal display position of menu screen.
OSD V-POSITION
Adjusts the vertical display position of menu screen.
MONITOR (for PN-E421 only)
Select the installation direction of the monitor.

LANDSCAPE ............Horizontal orientation

PORTRAIT ...............Vertical orientation
MONAURAL AUDIO
Outputs audio signals as monaural.
LANGUAGE
Sets the display language for the menu screen.
POWER ON DELAY
You can delay the screen display after the monitor is turned 

on. The period can be set up to 60 seconds in units of one 

second. When this function is activated, the power LED 

flashes (at approx. 1 second interval) in orange. This function 

is disabled when 0 is specified.
STANDBY MODE
When STANDARD is selected, startup time from standby 

mode is reduced. Note, however that, more power will be 

consumed in standby mode.

When LOW POWER is selected, current consumption 

is reduced while the monitor is in standby mode. Note, 

however, that the startup time from standby mode becomes 

longer. Also, certain RS-232C commands cannot be used 

in standby mode, and control via LAN will be disabled. (See 

pages 22 and 29.)
HDMI SETTING
HDMI AUTO VIEW

 ......................... When ON is selected, the screen size is 

adjusted automatically according to the 

screen size control signal included in the 

video signal input from the AV HDMI input 

terminal.

HDMI RGB INPUT RANGE

 ......................... Sets the type of HDMI signals when using 

the AV HDMI input mode. 

When AUTO is selected, the type is set 

automatically.

HOT PLUG CONTROL
Sets whether to use hot plug control for the PC/AV HDMI 

and PC/AV DVI-D input terminals.

RS-232C/LAN SELECT
Selects the method with which to control the monitor from 

the computer.
ID No. SET
Assigns ID numbers to monitors connected in a daisy chain 

(see page 19), using RS-232 cables.

The numbers 1 to 255 are available for ID numbers.

If “0” is set, the system regards this as the state where no ID 

number is set.
BAUD RATE
Selects the communication speed used for RS-232C 

communication.
LAN SETUP
Configures the settings to control the monitor from the 

computer via LAN. (See page 29.)
SPEAKER SELECT
Selects the speaker to be used.
OPTION DC OUT SETTING
Normally, leave this setting as OFF.

When using an optional part, if instruction appears, change 

the setting accordingly.