Read Sharp PN-70TB3 (serv.man9) User Guide / Operation Manual online
64
E
When “AUTO DIMMING” is displayed.
• When the internal temperature of the monitor rises
excessively, the brightness of the backlight automatically
decreases in order to prevent a further temperature rise. If
you attempt to use
you attempt to use
to adjust the brightness while
the monitor is in this state, “AUTO DIMMING” is displayed
and you cannot change the brightness.
• Remove the cause of the excessive temperature rise.
The monitor makes a cracking sound.
• You may occasionally hear a cracking sound from the
monitor. This happens when the cabinet slightly expands
and contracts according to change in temperature. This
does not affect the monitor’s performance.
The Power LED is flashing in red and green alternately.
When “TEMPERATURE” is displayed in the corner of the
screen.
• When the internal temperature of the monitor rises
excessively, the brightness of the backlight decreases
automatically in order to prevent high-temperature-
related problems. When this occurs, “TEMPERATURE” is
displayed on the screen and the Power LED flashes red
and green alternately. (When TEMPERATURE ALERT is
set to OSD & LED. This varies depending on the setting.)
• If the internal temperature rises further, the monitor
automatically enters standby mode. (The Power LED
continues flashing red and green alternately.)
• Remove the cause of the excessive temperature rise.
- If the monitor enters standby mode due to a rise in
temperature, to return to normal display, turn the power
switch off and then back on again. The monitor, however,
will enter standby mode again if the cause of the
temperature rise is not eliminated. (See page 7.)
- Check whether the monitor is placed at a location where
a quick rise in temperature is likely. Internal temperature
rises quickly if the vents on the monitor are blocked.
- Internal temperature rises quickly if dust accumulates
inside the monitor or around the vents. Remove dust if
possible. Ask SHARP dealer about removing internal dust.
Troubleshooting
Whiteboard display positions are out of place.
Noise appears on the whiteboard
• Try the automatic screen adjustment.
(1) Switch the input to WHITEBOARD.
(2) Touch the launch button.
The launcher appears.
(3) Touch [Setting].
You will be prompted to enter a password.
(4) Enter the password and touch [OK].
Enter the password set in the Admin Password setting.
If a password is not set, enter “00000”.
(5) Touch [Admin Settings] and [Start Screen Adjust Tool].
(6) Press
MENU
and use
or
to display the SCREEN
menu.
(7) Press
ENTER
and select “AUTO”.
(8) Press
ENTER
.
The automatic adjustment is complete in several
seconds.
(9) Press
MENU
to close the menu screen.
(10) Touch the screen to close the adjustment pattern.
(11) Touch [Cancel].
You will return to the whiteboard screen.
Click on the first or last page to see other PN-70TB3 (serv.man9) service manuals if exist.