Read Sharp PN-70TA3 Handy Guide online
Other function
5
●Quick start
・This display have quick start function which you can start within around 5 seconds
from pressing the POWER button.
Please set “
from pressing the POWER button.
Please set “
Whiteboard standby mode”
in advance by referring to follows.
POWER button / Power LED
Remote controller
■Preparation in advance
1) Insert POWER code to socket and turn on main power.
2) Press the POWER button by remote controller
or POWER button.
Power LED are changed to “Green lit”,
and White board will start after around 2 minutes.
3) Press the POWER button by remote controller
or POWER button.
Power LED are changed to “Orange flashing”,
the display will go “whiteboard standby mode”.
1) Insert POWER code to socket and turn on main power.
2) Press the POWER button by remote controller
or POWER button.
Power LED are changed to “Green lit”,
and White board will start after around 2 minutes.
3) Press the POWER button by remote controller
or POWER button.
Power LED are changed to “Orange flashing”,
the display will go “whiteboard standby mode”.
■Quick start, and “whiteboard standby mode” again
1) Press the POWER button by remote controller or
POWER button when it is “whiteboard standby mode”
1) Press the POWER button by remote controller or
POWER button when it is “whiteboard standby mode”
(Power LED : Orange flashing), then white board can
start within around 5 seconds
start within around 5 seconds
2) Press the POWER button by remote controller
or POWER button.
Power LED are changed to “Orange flashing”,
the display will go “whiteboard standby mode”.
So in next time white board can start within
around 5 seconds again.
POWER button / Power LED
Remote controller
[ Caution ]
■ In case of turning off main power or ejecting POWER code
If you want to turn off main power or eject POWER code, please operate after checking that you hold down POWER button in left
bottom until the exit screen appears and you can see Orange lit.
1) Hold down POWER button in left bottom
until the exit screen appears.
* Even if other video signal is inputted, please check you can see Orange lit in Power LED and operate same way as above
■ In case of turning off main power or ejecting POWER code
If you want to turn off main power or eject POWER code, please operate after checking that you hold down POWER button in left
bottom until the exit screen appears and you can see Orange lit.
1) Hold down POWER button in left bottom
until the exit screen appears.
* Even if other video signal is inputted, please check you can see Orange lit in Power LED and operate same way as above
Remote controller POWER button / Power LED
2) Check you can see Orange lit in Power LED.
3) Turn off main power and then eject POWER code.
3) Turn off main power and then eject POWER code.
Click on the first or last page to see other PN-70TA3 service manuals if exist.