LL-T2020 (serv.man18). Connecting the monitor and turning the monitor on and off - Sharp Monitor User Guide / Operation Manual. Page 2

Connect the analog signal cable to the analog RGB
output terminal of the computer.

- Paying attention to connector direction, firmly

insert the signal cable to terminal, and then
tighten the screws at both sides.

If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal cable.

Note:
- If connecting to the Sun Ultra series, a

conversion adapter (commercially available) may
be required.

Connect the digital signal cable to the digital RGB
output terminal of the computer.
- For digital RGB connection, the monitor has an

input for connecting to a computer with a DVI-
compatible output connector (DVI-D 24 pin or
DVI-I 29 pin) and UXGA output capability.
(Depending on the type of computer to be
connected, the display may not work correctly.)

- Use the accessory digital signal cable or an NL-

C04J cable (sold separately).
If using other commercially available digital
signal cables, correctly display may not be
achieved. UXGA resolution may not be available
when using the NL-C01E digital signal cable.

Macintosh conversion adapter

- Paying attention to connector direction, firmly

insert the signal cable to terminal, and then
tighten the screws at both sides.

Set the monitor as follows when establishing a
digital connection with a Power Mac using an ADC-
DVI adapter made by Belkin. (Operation has been
checked with the Power Mac G4 M7627J/A)
- Perform settings with the Power Mac power

supply off.

1.After connecting the power cord, turn on the

monitor’s main power.

2.Press the   button and   button simultaneously,

and while doing this press the POWER button
(i.e. turn the power on).

M AC   D I G I TA L

I N P U T- 1

O F F O N

I N P U T- 2

O F F O N

3.Set the input terminal to which the Belkin ADC-

DVI adapter is connected to ON.
Use the 

 button to select [INPUT1] or

[INPUT2], and use the     buttons to select
[ON] and [OFF].
- Do not set to [ON] if you are not using a Belkin

ADC-DVI adapter, as this may result in
incorrect display.

4.Press the power button, and turn off the monitor

power.
This completes setting.

Analog signal cable

Analog RGB output
terminal

Input terminal 1 and 2
You can connect to
either side.

Digital signal cable

Digital RGB output
terminal

Input terminal 1 and 2
You can connect to
either side.