Read Sharp LL-T2000 (serv.man9) Service Manual online
LL-T2000A
2 – 3
Notes: • Depending on the computer or OS, it may be necessary to
use the computer to install monitor set-up information. If so,
follow the steps below to install the monitor set-up informa-
tion.
follow the steps below to install the monitor set-up informa-
tion.
• When setting up the monitor or a connected computer for the
first time, connecting an additional computer or after having
changed an aspect of the current system, perform an auto-
matic screen adjustment before use.
changed an aspect of the current system, perform an auto-
matic screen adjustment before use.
CHANGING BETWEEN INPUT TERMINALS
(INPUT 1
(INPUT 1
0
0
0
0
2)
When connected to two computers, use the INPUT button to switch
between input signal terminals (i.e. to choose which computer's
screen you want displayed.)
between input signal terminals (i.e. to choose which computer's
screen you want displayed.)
TURNING THE POWER OFF
1. Turn the computer off.
2. Press the monitor's power button.
The Power LED will disappear.
If the monitor is not going to be used for a long period of time, be
sure to unplug it from the AC outlet.
If the monitor is not going to be used for a long period of time, be
sure to unplug it from the AC outlet.
2. INSTRUCTIONS FOR ATTACHING A
VESA COMPLIANT ARM
An arm or stand based on the VESA standard (purchased separately)
can be attached to the monitor.
can be attached to the monitor.
Procurement of the arm or stand is at the customer's discretion.
Arms or stands able to be used
*
Attachments must satisfy the following.
*
Compatible with the VESA standard
*
Have a gap of at least 100 mm
u
100 mm between the screw holes
on the section to be attached
*
Not be likely to fall off or break off after being attached to the moni-
tor.
tor.
How to attach the arm or stand
Notes: • Do not bend the signal cable or the AC adapter cable nor
place weight on them. Doing so could lead to damage.
• While following these instructions, please also refer to the
installation instructions in the operation manual included with
the arm or stand.
the arm or stand.
1. Spread out a soft cloth on a suitable horizontal surface.
2. Being careful not to damage the monitor, gently lay the monitor on
it display-side down.
3. Remove the stand cover and the covers to the left and to the right.
4. Remove the two screws, and remove the cover.
5.
Remove the four screws and then remove the stand from the monitor.
6.
Attach the arm to the monitor with the four screws.
INPUT button
Pushing this button switches between input
signal terminals, so that the screen changes to
display any of the machines connected.
Pushing this button switches between input
signal terminals, so that the screen changes to
display any of the machines connected.
OFF
Turn off device to
which monitor is
connected
which monitor is
connected
Turn monitor off
Press power button
(Rear view)
Stand cover
Lift one side
Cover
Two screws
Stand
8~10mm
The screws used to attach the arm should be M4 screws
with a length of 8 mm ~ 10 mm protruding from the surface
to be attached.
Using any other kind of screw may lead to the monitor
falling off or damage to the internal part of the monitor
with a length of 8 mm ~ 10 mm protruding from the surface
to be attached.
Using any other kind of screw may lead to the monitor
falling off or damage to the internal part of the monitor
Screw used to attach arm
Arm
Part of monitor to which arm is attached
Click on the first or last page to see other LL-T2000 (serv.man9) service manuals if exist.