LL-T19D1 (serv.man14). Complete - Sharp Monitor User Guide / Operation Manual. Page 11

Connect the separately-sold digital signal cable
(NL-C01E) to the digital RGB output terminal of the
computer.
- The monitor has an input for connecting to a

computer with a DVI-compatible output connector
(DVI-D24 pin or DVI-I29 pin) and SXGA output
capability. (Depending on the type of computer to
be connected, the display may not work
correctly.)

- Paying attention to connector direction, firmly

insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.

DVI-D input terminal

Digital signal cable

Digital RGB output
terminal

- When connecting, ensure that both the monitor

and computer are switched off.

- Be careful not to overly bend the cable or add

extension cords as this could lead to a
malfunction.

Connect the analog signal cable to the analog RGB
output terminal of the computer.
- For analog connection, use the analog signal

cable accessory or a commercially available one
(both ends should be mini D-sub15 pin).

- Paying attention to connector direction, firmly

insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.

If connecting to a D-sub15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal cable.

Note:
- If connecting to the Sun Ultra series, a

conversion adapter (commercially available) may
be required.

Analog signal cable

Analog RGB output
terminal

Macintosh conversion adapter

Analog RGB input terminal
1 and 2
You can connect to either
side.

T19D1_gb.p65

2/14/2003, 3:07 PM

11