LL-T1810A (serv.man10). Chapter 1-3 - Sharp Monitor Service Manual (repair manual). Page 6

When connecting, ensure that both the monitor and computer are
switched off.

Note: If connecting to the Sun Ultra series, a conversion adapter

(purchased separately) may be required.

A RGB signal cable (to be purchased separately) is needed to con-
nect a second computer.

1. Remove the cover

2. Connect the RGB signal cable (purchased separately) to the IN-

PUT 2 terminal.

3. Replace the cover.

This monitor can be used with hubs which use the USB standard
(Rev. 1.1).

USB devices such as keyboard and mouse can be connected here.
Up to 100mA of power is able to be supplied per port. Devices requir-
ing more than 100mA cannot be connected.

USB compatible computers and self-powered hubs can be con-
nected. (Bus-powered hubs cannot be connected.)

Notes:

•

If a USB cable is required, please use the one included.

•

Before connecting, ensure that the shape of the USB cable
connector is correct.

•

For information regarding the USB function (such as set-up)
please refer to the operation manual of the computer to be
connected.

•

Some devices may not be able to be activated. To ascertain
a certain device’s USB compatibility, please contact the
manufacturer of the device.

1. Remove the cover.

2. Connect the USB cable.

3. Replace the cover.

When connecting, ensure that both the monitor and computer are
switched off.

Firmly insert the analog RGB output terminal
(mini D-sub 15 pin with 3 rows) then tighten the
screws each side.

RGB cable

If connecting to a D-sub 15 pin 2 row Apple
Power Macintosh, attach a Macintosh conversion
adapter (to be purchased separately) to
the RGB signal cable.

Macintosh conversion adapter

RGB signal cable
After connecting the adapter, 
tighten the screws on each side 
to fix into place.

(Rear View)

Cover

INPUT 2 terminal

RGB signal cable
(purchased separately)

To the computer's 
RGB output terminal

(Rear View)

Cover

USB port: Downstream (2 ports)

USB port: Upstream (1 port)

ON

Turn monitor on 

Turn on device to 
which monitor is 
connected

Press power button