LL-T1620 (serv.man20) - Sharp Monitor User Guide / Operation Manual. Page 31

An arm or stand based on the VESA standard
(commercially available) can be attached to the
monitor.
Procurement of the arm or stand is at the custom-
er's discretion.

Attachments must satisfy the following.
- Compatible with the VESA standard
- Have a gap of 75 mm x 75 mm between the

screw holes on the section to be attached.

- Not be likely to fall off or break off after being

attached to the monitor.

- Be careful not to overly bend the cable or add

extension cords as this could lead to malfunction.

- While following these instructions, please also

refer to the installation instructions in the
operation manual included with the arm or stand.

1. Turn off the monitor’s power and unplug AC plug

from AC outlet.

2. Remove the cable.
3. Spread out a soft cloth on a suitable horizontal

surface.

4. Being careful not to damage the monitor, gently

lay the monitor on it display-side down.

5. Remove the four screws and then remove the

stand from the monitor.

Notes:
- The stand is specially made for use with this

monitor. Once having removed the stand, never
attempt to attach it to another device.

- Once having removed the screws, store them

together with the stand and if the stand is ever
re-attached be sure to use the original screws.
Using different screws could lead to a
malfunction.

6. Attach the arm to the monitor with the four

screws.

Notes:
- The screws used to attach the arm should be M4

screws with a length of 6 mm ~ 8 mm protruding
from the surface to be attached. Using different
screws could lead to malfunction or may lead to
the monitor falling off,internal damaged,personal
injury.

6 - 8 mm

Screw used to attach arm

Arm

Part of monitor to which
arm is attached