LL-T1620 (serv.man19) - Sharp Monitor User Guide / Operation Manual. Page 13

When connecting to an analog RGB output terminal:
- Use an analog signal cable (model name: NL-

C02E).

- Paying attention to connector direction, firmly

insert the signal cable to terminal, and then
tighten the screws at both sides.

Set the monitor as follows when establishing a
digital connection with a Power Mac using an ADC-
DVI adapter made by Belkin. (Operation has been
checked with the Power Mac G4 M7627J/A)
- Perform settings with the Power Mac power

supply off.

- The setup screen automatically disappears

approximately 30 seconds after the last command.

1. After connecting the power cord, turn on the

monitor’s main power.

2. Press the   button and   button simultaneously,

and while doing this press the POWER button
(i.e. turn the power on).

MAC DIGITAL

INPUT-2

OK    [ MENU ]

ON

OFF

3. Set to "ON" with the     buttons.

- Do not set to [ON] if you are not using a Belkin

ADC-DVI adapter, as this may result in
incorrect display.

4. Press the MENU button.

This completes setting.

Display cable
(purchased separately)

RGB output terminal

DVI-I input terminal

When the accessory audio cable is connected to
the audio output terminal of the computer, the
sound of the connected computer is output from
the display speakers. You can also use the
headphone jack of the display.

- If you plan to use a commercially available cable,

obtain one with no resistance.

Headphones (commercially available) can be
connected.

Notes:
- When the headphones are connected, no sound

can be heard from the monitor speakers.

Audio input
terminal

Audio cable

Audio output terminal

Headphone
terminal

Headphones