Read Sharp LL-T15G4 (serv.man2) User Guide / Operation Manual online
17
English
Deutsch
Français
Italiano
Español
English
Adjusting the screen display
(When using an analog signal)
Manual screen adjustment
Adjustments can be made using OSD (On Screen
Display) Menu provided.
Display) Menu provided.
1. Display an image that makes the entire screen
very bright. If using Windows, you can open and
use the Adjustment Pattern on the
accompanying Utility Disk. (p.16)
use the Adjustment Pattern on the
accompanying Utility Disk. (p.16)
2. Press the MENU button.
The ADJUSTMENT Menu will be displayed.
ADJUSTMENT
MANUAL
AUTO
CLOCK
127
PHASE
30
H-POS
200
V-POS
29
1024x768
ANALOG
V : 6 0Hz
H : 4 8.4kHz
At this point relevant menu options can be
adjusted.
Each time the MENU button is pressed the next
menu is selected. (ADJUSTMENT
adjusted.
Each time the MENU button is pressed the next
menu is selected. (ADJUSTMENT
→
GAIN
CONTROL
→
WHITE BALANCE
→
MODE
SELECT
→
OSD Menu disappears)
Notes:
- The OSD Menu automatically disappears
- The OSD Menu automatically disappears
approximately 30 seconds after the last
command.
command.
- This explanation is based on using the
Adjustment Pattern (for Windows) to make
adjustments.
adjustments.
ADJUSTMENT Menu
ADJUSTMENT
MANUAL
AUTO
CLOCK
127
PHASE
30
H-POS
200
V-POS
29
1024x768
ANALOG
V : 6 0Hz
H : 4 8.4kHz
MANUAL: Individual menu options are manually
adjusted.
AUTO:
Every menu option is automatically
adjusted.
adjusted.
Notes:
- Press the button to select [AUTO].
- To choose a menu option:
- Press the button to select [AUTO].
- To choose a menu option:
/ MODE button
- To go to the next menu: MENU button
CLOCK
The figure below demonstrates how to adjust so that
The figure below demonstrates how to adjust so that
vertical flicker noise is not emitted. ( buttons)
PHASE
The figure below demonstrates how to adjust so
that horizontal flicker noise is not emitted.
The figure below demonstrates how to adjust so
that horizontal flicker noise is not emitted.
( buttons)
Note:
- Adjustments to [PHASE] should be made only
Note:
- Adjustments to [PHASE] should be made only
after [CLOCK] has been correctly set.
H-POS (horizontal positioning) and V-POS
(vertical positioning)
To center the Adjustment Pattern within the
boundaries of the screen, adjust the left-right (H-
POS) values and the up-down (V-POS) values.
(vertical positioning)
To center the Adjustment Pattern within the
boundaries of the screen, adjust the left-right (H-
POS) values and the up-down (V-POS) values.
( buttons)
Vertical flicker noise
Horizontal flicker noise
Adjustment
Pattern
Screen frame
Untitled-40
2003/09/10, 15:41
17
Click on the first or last page to see other LL-T15G4 (serv.man2) service manuals if exist.