LL-T15G3 (serv.man17). Complete - Sharp Monitor User Guide / Operation Manual. Page 11

- When connecting, ensure that both the monitor

and computer are switched off.

- Be careful not to overly bend the cable or add

extension cords as this could lead to a
malfunction.

- Paying attention to connector direction, firmly

insert the signal cable to terminal, and then
tighten the screws at both sides.

If connecting to a D-sub 15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal cable.

Note:
- When connecting to a notebook, if the notebook

computer's screen is set so that it is displaying at
the same time, the MS-DOS screen may not be
able to display properly. In this case, change the
settings so that only the monitor is displaying.

Analog RGB terminal
(Mini D-Sub 15 pin, 3 row)

Analog signal cable

Macintosh conversion adapter

1.Press the monitor's POWER button.
2.Turn on the computer.

The power LED will be lit green, and the screen
will display an image.

ON

Notes:
- If using the monitor for the first time or after

having changed the system settings during use,
perform an automatic screen adjustment.

- Depending on the computer or OS, it may be

necessary to use the computer to install monitor
set-up information. If so, follow the steps below to
install the monitor set-up information.

1. Turn the computer off.
2. Press the monitor's POWER button.

The Power LED will disappear.

OFF

If the monitor is not going to be used for a long
period of time, be sure to unplug it from the AC
outlet.

Power terminal

Power cord

AC outlet

Turn on the
computer

Press power button

Turn the
computer off

Press power button

02_LL-T15G3_gb.p65

10/28/2002, 9:04 AM

11