LL-T15G1 (serv.man7). Complete - Sharp Monitor Service Manual (repair manual). Page 8

LL-T15G1/E15G1

CONNECTION, ADJUSTMENT, OPERATION AND FUNCTIONS

2 – 3

■

Installing the monitor’s ICC profile. (If the set-up information has already
been installed, so too has the profile, and there is no need to install it.)

This explanation assumes that the floppy disk drive is “A drive”.

1.  Place the Utility Disk in the computer’s A drive.

2.  Click on the [Start] button. From [Settings], choose [Control Panel].

3.  Double click on [Display].

4.  Click on [Settings] and [Advanced].

5.  Click on [General] and from [Compatibility] select [Apply the new

display setting without restarting], then click on [Color Manage-
ment].

6.  Click [Add], and select [3 

1

/

2

 Floppy [A:]] as the file location.

7.  Choose the color profile that you would like to install, and click on

[Add].

8.  Choose the profile and click on [Set As Default].

9.  Click [OK], and close the window.

10. Remove the Utility Disk from the A drive.

• When using the ICC profile, please set the [WHITE BALANCE] to

[STD].

An arm based on the VESA standard can be attached to the monitor.
The arm must be purchased separately.

When choosing the arm to be installed please take note of the following

points.

• The arm should be compatible with the VESA standard, and there

must be a gap of 75mm 

u

 75mm between the screw holes on the sec-

tion to be attached.

•  The arm must not fall off or break off after being attached to the mon-

itor.

Note: Do not overly bend the cable or add extension cords as this

could lead to malfunction.

1.  Ensure that both the monitor and computer are switched off.

2.  Remove the AC adapter and the RGB signal cable.

3.  Press down on the stand and gently fold back the monitor.

Be sure to completely fold the monitor back to stopping point.

If it is attempted to install the arm while the monitor is not com-

pletely folded back, the monitor may suddenly fall, leading to mal-
function.

Be careful not to pinch your fingers.

4.  Being careful not to damage the monitor, spread out a soft cloth and

lay the monitor on it display-side down.

5. Attach the arm to the monitor with four screws.

6.  Connect the AC adapter and the RGB signal cable.

Information
The screws used to
attach the arm should be
M4 screws with a length
of 4 mm ~ 6 mm protrud-
ing from the surface to be
attached. Using any other
kind of screw may lead to
the monitor falling off or
damage to the internal
part of the monitor.

4 ~ 6 mm

Screw used to
attach arm

Arm

Part of monitor to
which arm is
attached