LL-T15A1 (serv.man6). Complete - Sharp Monitor Service Manual (repair manual). Page 5

When connecting, ensure that both the monitor and computer are
switched off.

Note: Do not overly bend the cable or add extension cords as this

could lead to malfunction.

Before connecting, first turn off the monitor’s main power switch.

Note: Do not overly bend the cable or add extension cords as this

could lead to malfunction.

1.

Connect the AC adapter to the monitor’s power terminal

2.

Attach the power cord to the AC adapter and place the power
plug into the AC terminal

1.

Turn on the computer.

2.

Press the monitor’s power button.
The power LED will be lit green, and the screen will display an
image

Note: When setting up this monitor for the first time or after having

changed an aspect of the current system, perform an automat-
ic screen adjustment before use.

■

Depending on the computer or OS, it may be necessary to use the
computer to operate the installation of monitor set-up information etc.
If so, follow the steps below to install the monitor set-up information. 

Notes:

·

Depending on the computer type, command names and
methods may differ. Please follow the computer’s own op-
eration manual while reading this.

·

This explanation assumes that the floppy disk drive is "A
drive". If the floppy disk drive of your computer is not "A
drive", please read the below substituting the floppy disk
drive you are using in place of "A drive" or "A".

Installing monitor set-up information into Windows95. 

This explanation assumes that the floppy disk drive is "A drive".

1.

Place the Monitor Settings Adjustment Disk (provided) into the
computer’s A drive.

2.

Click on the [Start] button. From [Settings], choose [Control
Panel].

3.

Double click on [Display].

4.

Click on [Settings], [Advanced Properties], and [Monitor], then
[Change].

5.

Click on [Have Disk], confirm that [Copy manufacturer’s files
from:] is [A:] then click [OK].

6.

Confirm that the monitor details are selected, and click [OK].

7.

Check that the monitor details are displayed, then click [Apply].

Firmly insert the analog RGB output terminal 
(mini D-sub 15 pin with 3 rows) then tighten the 
screws each side.

RGB cable

If connecting to a D-sub 15 pin 2 row Apple Power 
Macintosh, attach a Macintosh conversion adapter 
(to be purchased separately) to the RGB signal 
cable.

Macintosh conversion adapter

RGB signal cable
After connecting the adapter, tighten 
the screws on each side to fix into place.

Power terminal

AC adapter

Power cord

Power LED

Power button