LL-T1512W (serv.man9). LLT1512W - Sharp Monitor User Guide / Operation Manual. Page 13

When you use a Digital signal cable (to be
purchased separately), plug the Digital signal
cable’s connector into DVI-D input connector and
fix with screws each side.

When you use only the digital signal cable, it
allows you to remove the analog signal cable.
(Disconnect by loosening the screws each side.)

6. Close the cover (c).

Slide the cover (c) ahead slowly until the hooks
each side reach to catchers. Be careful not to put
the cables between any others.

7. Close the cover (b).

1) Run cable through the opening of the cover,

and insert the hooks each side into projection.

2) Push slowly the upper side of the cover until

the hooks click into place.

8. Close the cover (a).

1)  Insert the three hooks into the slit.
2) Push slowly both sides of the cover until the

three hooks click into place.

9. Connect the AC cord to the AC adapter inlet, and

plug into AC outlet.

When you remove the cover (b), you must
disconnect the AC cord from AC adapter inlet. It
is impossible to remove the cover (b) when power
cord is connected to AC adapter.
(When you are faced with an AC cord tightened
into AC adapter, please pull it off slowly and
carefully.)

Digital signal cable (to be purchased separately)