LL-T1512 (serv.man8) - Sharp Monitor User Guide / Operation Manual. Page 14

Connect this device’s analog signal cable to the
computer (PC etc.)
Before connecting the cable, ensure that both the
monitor and computer are switched off.
Be careful not to overly bend the cable or add stress
onto the cable as this could lead to malfunction.

When setting up this monitor for the first time or after
changing the configuration of the system in use,
perform an Automatic Screen Adjustment (page 21).
(It is not required to perform this process when the
monitor is used in digital signal input mode)

If the monitor is connected to a Note PC and set to
display simultaneously on the PC's screen, the MS-
DOS screen may not be displayed. If this occurs,
you are suggested to set the display on the Note PC
only.

Connecting the monitor to a computer via a Digital
signal cable (to be purchased separately)
Before connecting the cable, ensure that both the
monitor and computer are switched off.

This connection is available for connecting to a
computer with DVI compatible output connector
(DVI-D24 pin or DVI-I 29 pin) and XGA output
capability. (Depending on the type of computer to
be connected, the display may not work
correctly)

Be careful not to overly bend the cable or add
stress onto the cable as this could lead to
malfunction.

Paying attention to connector direction, firmly
insert the analog signal cable to here, and then
tighten the screws at both sides.

If connecting to a D-sub 15 pin 2 row Apple
Power Macintosh, attach a Macintosh conver-
sion adapter (to be purchased separately) to
the analog signal cable.

After connecting the adapter, tighten the
screws on each side to fix into place.

Macintosh
 conversion adapter

Paying attention to connector direction, firmly
insert the digital signal cable to here, then tighten
the screws each both sides.

Digital signal cable(to be parchased separalely)

Analog signal cable