Read Sharp LL-T1501A (serv.man13) Service Manual online
ible, [OUT OF TIMING] will appear. Follow your computer’s
instruction manual to set the timing to be compatible with the
SIGNAL] will appear.
card and the computer must conform to the VESA DPMS standard.
monitor or PC. It transfers information such as degree of resolution
between the monitor and PC. You can use this function if your PC is
DDC compliant and if it is set so that it can detect the Plug & Play
systems. This monitor works with DDC1 and DDC2B.
switch is on. (After turning the power on, it may take a little time
before the screen displays.) Press the button again to turn the
These buttons are used to increase or decrease the value of a
When the OSD Menu is not displayed:
These buttons are used to adjust backlight brightness.
On [AUTO] setting the brightness sensor will automatically adjust
to the right brightness.
adjust it to a suitable viewing angle.
sure to hold the green section only.
Pressure from hands on the LCD panel
could cause damage.
can be connected to a USB device.
A USB-ready computer or
self-powered USB hub can
be connected here.
By connecting a security lock (purchased separately) to the
security lock anchor, the monitor is fixed so that it cannot
Kensington Micro Saver Security Systems.
This is to be connected to the
computer's analog RGB output
The power cord is
openings as this may lead to
overheating inside the monitor
and result in malfunction
( I ) Turns the monitor on.
(O) Turns the monitor off.
A USB device can be connected
(mini D-sub 15 pin with 3 rows) then tighten the
screws each side.
Macintosh, attach a Macintosh conversion adapter
(to be purchased separately) to the RGB signal
After connecting the adapter, tighten the
screws on each side to fix into place.
USB hub’s downstream port