Read Sharp LL-T1500A (serv.man13) Service Manual online
CHAPTER 3. CONNECTION, ADJUSTMENT, OPERATION AND FUNCTIONS
[1] CONNECTING POWER SUPPLY AND
COMPUTER
·
Make sure both the LCD monitor and computer are OFF.
Connect the signal cable to the analog output terminal of the
computer. Make sure to tighten the connector screws of the cable.
computer. Make sure to tighten the connector screws of the cable.
Connect the power supply cable to the wall outlet.
Turn on the main power switch of the monitor and then turn on the
computer power switch.
computer power switch.
When the monitor power switch is turned on, the green power-on
lamp comes on and the screen appears. Adjust the screen
lamp comes on and the screen appears. Adjust the screen
Automatic screen adjustment
After using the monitor, turn off the main power switch.
Rear view
[CAUTION]
·
When removing the power cable, make sure that both the com-
puter and the monitor are OFF and hold the connector, but not the
cable.
puter and the monitor are OFF and hold the connector, but not the
cable.
·
When you are going to connect the monitor to a Power Macintosh
machine, you might need to a commercial Macintosh conversion
adapter.
machine, you might need to a commercial Macintosh conversion
adapter.
Upper fluorescent lamp lead wire
Screw A (upper)
Cover
Tape
Screw A (lower)
Lower fluorescent lamp
lead wire
lead wire
Fig. 2
CN2
Cover
CN2
CN1
LCD module : VVLQ150X1DH10
Lamp umit : DUNTH2162TPZZ
Lamp umit : DUNTH2162TPZZ
To the computer
Signal cable
To the AC outlet
Power cord