LL-191A (serv.man3) - Sharp Monitor User Guide / Operation Manual. Page 13

- When connecting, ensure that both the monitor

and computer are switched off.

- Be careful not to over bend the cable or add

extension cords as this could lead to a
malfunction.

Connect the accessory analog signal cable to the
analog RGB output terminal of the computer.

- Paying attention to connector direction, firmly

insert the signal cable vertically into the
connector, and then tighten the screws at both
sides.

If connecting to a D-sub15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.

Note:
- If connecting to the Sun Ultra series, a

conversion adapter (commercially available)
may be required.

Analog signal cable

Analog RGB terminal
(Mini D-sub 15 pin, 3 row)

Analog RGB terminal
(Mini D-sub 15 pin, 3 row)

Macintosh conversion adapter

When the accessory audio cable is connected to
the audio output terminal of the computer, the
sound of the connected computer is output from
the monitor speakers. You can also use the
headphone jack of the display.

Audio output terminal

Audio cable

Audio input terminal

191A_gb.P65

12/15/2003, 5:27 PM

13