LL-171ME (serv.man5) - Sharp Monitor User Guide / Operation Manual. Page 12

- When connecting, ensure that the monitor and all the equipment you are connecting to it are switched

off.

- Be careful not to over bend the cable or add extension cords as this could lead to a malfunction.
- When using the monitor for the first time or after having changed the system settings during use,

perform an automatic screen adjustment (see page E17).

See page E6 for information on removing/replacing the terminal cover.

Audio output terminal
The monitor’s speakers will play the computer’s
audio when you connect the two devices with the
PC audio cable accessory.

Notes:
- Depending on the computer or OS, you may

have to install the set-up information for the
monitor. (See page E26.)

- When connecting to a notebook and the

notebook computer’s screen is set so that it is
displaying at the same time, the MS-DOS screen
may not be able to display properly. In this case,
change the settings so that only the monitor is
displaying.

If connecting to a D-sub15 pin 2 row Apple Power
Macintosh, attach a Macintosh conversion adapter
(commercially available) to the analog signal
cable.

Macintosh conversion adapter

Analog RGB terminal
(Mini D-sub15 pin 3 rows)
Paying attention to the connector direction, firmly
insert the signal cable straight into the connector, and
then tighten the screws at both ends.

PC analog signal cable
(accessory)

PC audio cable
(accessory)

Power Macintosh

LL-171ME_gb_01.PMD

2/2/2004, 2:43 PM

10